Limiter (Speaker Processor); Output Router - Yamaha TX4n Reference Manual

■ Limiter (Speaker Processor)

This compresses signals exceeding the threshold at ∞:1, preventing signals higher than the threshold level from being output.
Parameter name
On
Threshold
Attack Mode
Attack
Release Mode
Release

■ Output Router

Here you can specify the routing for the slot output. For each slot output channel, you can select from the following four types
of output points. For details on output points, refer to
MTXOut3/4
OscMixIn1/2
SpProcOutA/B
OSC1/2
Range
ON/OFF Turns the limiter on/off.
-54–0 dB Specifies the threshold value for the limiter.
Fast, Mid, Slow, Manual Selects the attack speed of the limiter. If the Manual setting is selected,
use the Attack setting below to specify the attack time. If Fast/Mid/Slow
is selected, the attack time is specified roughly according to the HPF
cutoff frequency of Speaker Processor's Crossover.
0.0–120.0 ms Specifies the attack time when Manual mode is selected.
Fast, Mid, Slow, Manual Selects the release speed of the limiter. If the Manual setting is
selected, use the Release setting below to specify the release time. If
Fast/Mid/Slow is selected, the release time is specified roughly accord-
ing to the HPF cutoff frequency of Speaker Processor's Crossover.
3 ms–21.1 s Specifies the release time when Manual mode is selected.
"SIGNAL PATH Block Diagrams" (page
Outputs 3/4 of the 4x4 Matrix Mixer
From outputs 1/2 of the 4x4 Matrix Mixer to immediately before mixing with the oscillator output
Outputs A/B of the Speaker Processor.
Oscillator outputs 1/2
Explanation
Fast : 1/4 wavelength of cutoff frequency
Mid : 1/2 wavelength of cutoff frequency
Slow : 1 wavelength of cutoff frequency
Fast : 4 wavelength of cutoff frequency
Mid : 8 wavelength of cutoff frequency
Slow : 16 wavelength of cutoff frequency
Panel Operations
30).
TX6n/5n/4n Reference Manual
39