Appendix; Message List - Yamaha TX4n Reference Manual

Appendix

Message List

Messages that may appear in the TXn's display and the appropriate responses are listed below.
Message
Panel
Full locked!
Panel
View only!
Parameter
Protected!
MUTE key
Locked!
ATT. Dial
Locked!
Scene recalling
Do not turn off!
Cannot edit
while online!
File writing
Do not turn off!
Calibrating
[EXIT] to cancel
Initializing
Do not turn off!
Updating f/ware
Do not turn off!
Synchronizing
Do not turn off!
Turning power on:
Are you sure?
No[EXIT] Yes[ENTER]
Going Standby:
Are you sure?
No[EXIT] Yes[ENTER]
Changing Freq. Type:
Are you sure?
No[EXIT] Yes[ENTER]
Press and hold [EXIT] key
to reset Fault Output
Reset Fault Output
Are you sure?
No[EXIT] Yes[ENTER]
To prevent unintended operation, panel operations have been locked by the panel lock setting.
To temporarily defeat panel lock, hold down both the [HOME] button and [EXIT] button for at least
three seconds. To turn panel lock off, first defeat it temporarily, and then turn the UTILITY screen ➝
Front Panel Operation ➝ Panel setting OFF.
To prevent unintended operation, parameter editing has been locked by the panel lock setting.
To temporarily defeat panel lock, hold down both the [HOME] button and [EXIT] button for at least
three seconds. To turn panel lock off, first defeat it temporarily, and then turn the UTILITY screen ➝
Front Panel Operation ➝ Panel setting OFF.
This message will appear if you attempt to perform panel operations to edit parameters of a Speaker
Processor component to which a library whose security setting was "View" or "Hide" was recalled.
If you want to defeat security, recall a library item whose security is set to "Edit."
To prevent unintended operation, the [MUTE] buttons have been locked.
To unlock the [MUTE] buttons, set the UTILITY screen ➝ Front Panel Operation ➝ MUTE Key setting
to Normal.
To prevent unintended operation, changes to the attenuation have been locked.
To unlock the attenuation, set the UTILITY screen ➝ Front Panel Operation ➝ Att. Dial setting to Nor-
mal.
A scene is being recalled. Never turn off the power while this message is shown.
Settings cannot be edited, because the unit is online with Amp Editor.
A file is being written to internal memory. Never turn off the power while this message is shown.
Calibration is being executed.
If you decide to cancel calibration, press the [EXIT] button.
Internal memory is being initialized. Never turn off the power while this message is shown.
The firmware is being updated. Never turn off the power while this message is shown.
Now synchronizing with Amp Editor. Never turn off the power while this message is shown.
This message will appear when the power is being switched from Standby to On.
To switch the setting, press the [ENTER] button.
This message will appear when the power is being switched from On to Standby.
To switch the setting, press the [ENTER] button.
This message will appear when you change the Frequency Type in the Signal Chain screen or the
Calibration screen.
To change the setting, press the [ENTER] button. When this is changed, the Output Signal Chain
parameters or Calibration parameters will return to their default values.
This will appear if the FAULT OUTPUT connector's output is set to on. Hold down the [EXIT] button
for three seconds or longer to reset the output (NC and C will be connected).
This will appear if the FAULT OUTPUT connector's output is set to on and you hold the [EXIT] button
for three seconds or longer to reset the output. Press the [ENTER] button to reset the output.
Explanation
TX6n/5n/4n Reference Manual
55