Basic Speaker Configuration - Yamaha CX-A5200BL Owner's Manual

Basic speaker configuration

If you do not multi-zone configurations, follow the procedure below to place the speakers in your room and connect them to the unit.
■ Placing speakers in your room
Depending on the number of speakers, place the speakers and subwoofer in your room. This
section describes the representative speaker layout examples.
X
• To have a full effect of Dolby Atmos contents, we recommend using a speaker system with a S mark. However,
you can also play back Dolby Atmos contents with the 7.1 system (using surround back speakers).
• To have a full effect of DTS:X contents, we recommend using a speaker system with a S mark.
• (About the number of channels) For example, "5.1.2" denotes "standard 5.1-channel plus 2 for overhead
speaker channels". For details on how to place overhead speakers (presence speakers), see "Presence speaker
layout" (p.26).
11.2-channel system [S7.2.4]
(using both surround back and rear presence speakers)
This speaker system brings out the full performance of the unit and allows you to enjoy a
highly-natural 3-dimensional sound field with any contents.
E
4
T
X
• When Zone3 output is enabled (p.103), the rear presence left/right channel output is not available in the main
zone.
• When using front presence and rear presence speakers installed to the ceiling or when using the Dolby Enabled
speakers as the presence speakers, configure the "Layout (Front Presence/Rear Presence)" setting in the
"Setup" menu before performing YPAO (p.43).
21
En
R
1 2
9 3 9
5
Y
6 7