Operations That Can Be Performed From The Panel - Yamaha TX4n Reference Manual

Panel Operations

Operations that can be Performed from the Panel

Category
METER ANA INPUT VOLTAGE
(page 16)
SLOT INPUT VOLTAGE
SP OUTPUT VOLTAGE
SP OUTPUT POWER
SP OUTPUT IMPEDANCE
SLOT OUTPUT METER
THERMAL
UTILITY Device Setup
(page 19)
Word Clock Setup
Information
Network Setup
LCD Setup
Front Panel Operation
Scene Setup
Misc Setup
MENU General
(page 24)
Signal Path
Signal Chain
Calibration
Limiter
SCENE Recall
(page 40)
Store
Edit
Clear
*Scene..........The settings listed above, such as Standby/Power-On or mute (with the exception of UTILITY), are called a "scene". By recalling a scene, the
saved settings can be immediately applied to the amplifiers.
14
TX6n/5n/4n Reference Manual
Subcategory
Shows the input level from the analog input connectors.
Shows the input level from the slot.
Shows the output level from the [SPEAKERS] connectors.
Shows the output power from the [SPEAKERS] connectors.
Shows the output impedance from the [SPEAKERS] connectors.
Shows the output level to the slot.
Shows the heat sink temperature.
Makes settings to distinguish the amplifier on a network.
Sets the word clock.
Shows information about the amplifier.
Specifies the IP address and other settings for using the amplifier in a
network.
Specifies the display settings.
Turns panel operation lock on/off.
Makes scene* settings.
Sets the amplifier's internal clock, etc.
Sensitivity/Amp Gain Sets the input sensitivity/gain.
Stereo/Bridge/Parallel Specifies the amplifier's mode (Stereo/Bridge/Parallel).
Attenuation Link Specifies whether attenuator operation will be linked between channels
A and B.
Input Redundancy Specifies the redundant connection mode, etc.
Makes settings for the equalizer, delay, crossover, and others that pro-
cess the audio signal. Speaker Processor libraries can also be recalled.
Analog Input Signal Chain Makes settings for checking whether the audio signal is being correctly
input from the analog connectors.
Slot Input Signal Chain Makes settings for checking whether the audio signal is being correctly
input from the slot.
Output Signal Chain Makes settings for checking the status of output from the [SPEAKERS]
connectors.
Calibrate by Pilot Tone Uses a pilot tone to measure the impedance of the connected speakers.
Calibrate by Prog Source Uses an audio signal to measure the impedance of the connected
speakers.
Voltage Limiter Makes settings for the limiter.
Power Limiter
Limiter Gain Reduction Specifies whether the limiter will be linked between channels A and B.
Recalls a scene*.
Stores a scene*.
Edits a scene*.
Clears a scene*.
Explanation