Download Print this page

Yamaha DSP-AX463 Owner's Manual Page 28

Yamaha av amplifier owner's manual.
Hide thumbs

Advertisement

Optimizing the speaker setting for your listening room
10
Press 7 n and then press 7 l / h to select
"SET" or "CANCEL".
Choices: SET, CANCEL
• Select "SET" to confirm the "AUTO SETUP"
results.
• Select "CANCEL" to cancel the "AUTO SETUP"
results.
Press 7 ENTER to confirm your selection.
11
The top "SET MENU" display appears in the OSD.
SET MENU
TOP MENU
. ;AUTO SETUP
;MANUAL SETUP
.A;SIGNAL INFO
[ ]/[ ]:Up/Down
[ENTER]:Enter
Press K MENU to exit from "SET MENU".
12
13
Disconnect the optimizer microphone from
this unit.
The optimizer microphone is sensitive to heat. Keep it
away from direct sunlight and do not place it on top
of this unit.
y
If you change speakers, speaker positions, or the layout of your
listening environment, run "AUTO SETUP" again to recalibrate
your system.
■ If an error screen appears
Press 7 k / n / l / h to select "RETRY" or
"EXIT" and then press 7 ENTER.
The following display is an example where "E-8:USER
CANCEL" appears in the OSD.
ERROR
. E-8:USER CANCEL
Can't detect
signal at MIC
>
RETRY
[ ]/[ ]:Select
[ENTER]:Enter
Choices: RETRY, EXIT
• Select "RETRY" to retry the "AUTO SETUP"
procedure.
• Select "EXIT" to exit from the "AUTO SETUP"
procedure.
26
En
EXIT
■ If "WARNING" appears
When this unit detects potential problems during the
"AUTO SETUP" procedure, "WARNING" appears in the
result display. Check the warning messages to correct your
speaker settings.
Note
Warnings differ from errors in that warnings do not cancel the
"AUTO SETUP" procedure.
1
Make sure the pointer is pointing at
"WARNING" and then press 7 ENTER to
display the detailed information about the
warning.
The number on the right of "WARNING" indicates
the number of warning messages.
AUTO SETUP
. WARNING(2)
RESULT
SP
DIST:
LVL :
>
SET
[ ]/[ ]:Up/Down
[ENTER]:Detail
2
Press 7 l / h repeatedly to toggle between
the warning displays.
WARNING
W-1:OUT OF PHASE
Reverse channel
AAAAFLAAAAA---
AAACENTER
AAAASLAAAAA---
[ ]/[ ]:Select
[ENTER]:Return
y
• For details about each warning message, see the "AUTO
SETUP" section in "Troubleshooting" on page 67.
• When the corresponding warning message is not
applicable to a speaker, "– –" is displayed instead.
Press 7 ENTER to return to the result
3
display.
:
3/2/0.1
3.2/3.5m
-2/+2dB
CANCEL

Advertisement

   Also See for Yamaha DSP-AX463

   Related Manuals for Yamaha DSP-AX463

This manual also for:

Dsp-ax563

Comments to this Manuals

Symbols: 0
Latest comments: