Operating The Gc 9000; Description Of The Function Keys - RMG EMC 500 Operating Instructions Manual

.........................................................................................................................................................................................................

Operating the GC 9000

Description of the function keys

1
Indication of the TIME
2
Indication of the DATE
3
EMC archives
4
Indication of the calibration modes and when pressing the
related to the calibration mode (except set values)
5
Indication of the current output No. 1 and when pressing the
related to this current output.
Press the
6
Indication of data for sensor 1 (measured value and parameters)
Press the
7
Selection of calculated values (e.g. H
8
Version parameter and test values (to check the calculations)
9
Indication of superior calorific value, Wobbe index, standard density, relative density,
inferior calorific value and CO
0
Indication calibration status and when pressing the
calibration status incl. start and results
± ,
Calibration report, data report, revision report
...........................................................................................................................................................................................................
Manual EMC 500 · EN01 · 2008-02
key to switch over to current outputs 2, 3 and 4.
key to reach data for sensor 2, pressure and temperatur values.
s,n
content incl. appropriate default values
2
ANALYTICAL COMPUTER GC 9000
, ρ , ...) and units
n
keys all values related to the
keys further values
keys all values
19