Table of Contents
Advertisement
11.
Diagnostics for AS-i Monitor and networking using AS-i Master
11.1
Introduction
The new AS-i Safety Monitor – in conjunction with Pepperl+Fuchs GmbH AS-i
Masters – offers not only superior on-location operation and diagnostics, but also
makes this also accessible over the network.
11.2
On-location operation
The Monitor display shows all the diagnostics data directly in the same manner as
on the Gateway with integrated monitor.
Information!
The menu is described on the separate menu page.
For characteristics which apply to both the 1
selected with this selection box:
11.3
Spontaneous messages
The strategy for spontaneous display of messages for AS-i masters is:
•
When the AS-i network is functioning error-free, a smiley is displayed.
•
When the fieldbus communication is failed, a text message is displayed.
•
When there is a fault on an AS-i slave, this is displayed until the fault is no
longer present.
For the Safety Monitor the desire is to keep the concept as similar as possible,
since it is so familiar to and accepted by customers.
When there are no faults present, the states of the safety unit are displayed as a
text beneath the smiley.
When two local release circuits are present, a line is displayed with their status, or
two lines for 4 local circuits.
82
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
Diagnostics for AS-i Monitor and networking using AS-i Master
AS-I CIRCUIT 1
AS-I CIRCUIT 2
☺Press OK for Menu
Output Circuit
1:ON
3:ON
AS-i Safety Monitor for 2 AS-i circuits
st
nd
and 2
AS-i circuit, the circuit is
2:ON
4:ON
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com
Advertisement
Table of Contents
