Table of Contents
Advertisement
TROUBLESHOOTING
PROBLEM
CAUSE
Does Not Run
When Switch
No electrical power to Sander
is Depressed
Motor Runs
Too Slow/
Undersized or too long of an
Develops
extension cord
Low Power
Excessive
Noise and/or
Abrasive Belt/Disc is damaged
Vibration
Motor
Excessive pressure being applied
Overheats
to Abrasive Belt/Disc
ADDITIONAL ITEMS
#15144
40 Grit, 6" PSA Abrasive Discs, 6-PK
#15145
80 Grit, 6" PSA Abrasive Discs, 6-PK
#15146
120 Grit, 6" PSA Abrasive Discs, 6-PK
#15147
180 Grit, 6" PSA Abrasive Discs, 6-PK
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: tech@eastwood.com
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com
© Copyright 2019 Eastwood Automotive Group LLC
CORRECTION
Check 120 VAC input plug connection
Check for tripped circuit breaker
Use only 18 gauge or larger cord.
Limit length to 25'.
This is an extremely dangerous condition! Stop Use and replace
WARNING:
Abrasive Belt!
Allow Abrasive Belt/Disc to cut by contact alone. Do Not Force.
10/19
Instruction item #22979Q
Rev 1
Advertisement
Table of Contents
