Table of Contents
Advertisement
ASSEMBLY
• Attach the selected Belt Table/Work Stop to the Belt Sander assembly with the
included 8mm Socket Head Cap Screw and Washer (FIG 1). Keep the bottom
edge of the Table/Stop approx. 0.063" [1.5mm] from the belt and tighten screw
securely (FIG 2). NOTE: Table/Stop should not contact sanding belt. Check for
contact with belt and re-adjust if necessary.
• Attach the Adjustable Disc Table/Miter Plate to the Disc housing by screwing the
two M6 threaded knobs and M6 washers into the housing, one on each side.
NOTE: Disc Table/Miter Plate should not contact sanding disc. Check for contact
with disc and re-adjust if necessary (FIG 3).
SET-UP
• Using suitable lag bolts or through bolts and nuts (not included), securely bolt the
housing flanges to a secure work surface to prevent tool movement while in use.
• The Belt Sander position is adjustable from horizontal to 90° vertical. To do so:
• Loosen 6mm socket head cap screw on Belt Sander Pivot Clamp with included
6mm wrench, choose your preferred working position for the Belt Sander, then
tighten screw securely locking it in position (FIG. 4). NOTE: Be certain the Belt
Sander assembly is securely clamped. Severe personal injury could occur if Belt
Sander Assembly position slips during use.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 1
FIG. 2
FIG. 3
FIG. 4
.063" (1.5mm)
5
Advertisement
Table of Contents
