Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Eastwood PRO MINI ANGLE
Summary of Contents for Eastwood PRO MINI ANGLE
- Page 1 Part #31649 3/4" X 20-1/2" PRO MINI ANGLE BELT SANDER INSTRUCTIONS...
-
Page 2: Specifications
The EASTWOOD 3/4” X 20-1/2” PRO MINI ANGLE BELT SANDER is compact and powerful with an adjustable angle and articulated sanding arm for ease in grinding and sanding in the most difficult to access areas. It features a sealed ball bearing drive assembly for smooth, low vibration operation and long life. -
Page 3: Safety Information
• This tool emits high sound levels while operating. Use ANSI approved ear protection when operating. BURSTING HAZARD! • Do not exceed 90 psi (6.2 bar) of tool inlet pressure. Permanent tool damage and/or bursting could occur and cause personal injury. To order parts and supplies: 800.345.1178 >> eastwood.com... -
Page 4: Setup And Connection
• Wrap white thread sealing tape (Not Included) around the threads of the included 1/4” Male NPT quick disconnect fitting, then thread it into the 1/4” NPT inlet threads of the Belt Sander Body. • Attach Air Supply to Inlet Fitting. Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com... -
Page 5: Operation
Guide Bar located on the upper surface of the Abrasive Belt Arm. • Depress the Thumb-Lever Latch to release the Guide Pin restoring full spring pressure (FIG 3). Push to unlatch To order parts and supplies: 800.345.1178 >> eastwood.com... - Page 6 50° of articulation. NOTE: Spring tension in the Arm must be maintained against the belt to retain it in place or it will fall off. Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
-
Page 7: Adjusting Belt Tracking
• If tool is to be unused for an extended period, add 10 drops of air tool oil directly to the air inlet then store the tool, inlet up. • With the air supply disconnected, periodically check that the belt is not worn, torn and is tight. To order parts and supplies: 800.345.1178 >> eastwood.com... -
Page 8: Troubleshooting
Rockwood Valved Dust Mask, 10-pack If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: techelp@eastwood.com PDF version of this manual is available at eastwood.com The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com...