The EASTWOOD 42” BELT & 6” DISC SANDER is designed for rugged reliability and ease of use. The positionable belt drive assembly provides a full 85° of adjustment from horizontal to vertical and features a secure stop fence/tool rest for safety and convenience. The 6” disc sander features an angle-adjustable work surface and sliding miter gauge/fence to allow grinding to precise angles with one convenient bench mounted tool.
Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. To order parts and supplies: 800.343.9353 >> eastwood.com...
• This Sander will eject a trail of sparks at high speed which can ignite flammable materials or injure others nearby. Do not operate in the vicinity of flammable materials and keep all persons and pets away from the work area. Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com...
Page 5
(FIG. 4). NOTE: Be certain the Belt Sander assembly is securely clamped. Severe personal injury could occur if Belt Sander Assembly position slips during use. FIG. 3 FIG. 4 To order parts and supplies: 800.343.9353 >> eastwood.com...
Page 6
FIG. 7 Unplug tool before beginning belt replacement or severe personal injury could result if motor should start during this procedure. Always use an Eastwood approved 2” x 42” sanding belt to insure safe operation. ABRASIVE BELT REMOVAL 1. Unscrew the two knobs on the plastic Belt Cover and remove the cover (FIG 7).
Unplug tool before beginning disc replacement or severe person- al injury could result if motor should start during this procedure. Always use an Eastwood approved 6” PSA sanding disc to insure safe operation. 1. Remove the Adjustable Disc Table/Miter Plate by loosening and removing the two knobs, one on each side (FIG 11).