Table of Contents
Advertisement
MAINTENANCE
• Before each use, check oil level by removing the Socket Head Screw located on top of the tool
body using the included 4mm hex key (FIG 3). If no oil level is visible, add several drops of air
tool oil until some oil can be seen. DO NOT OVERFILL. Replace screw and tighten securely.
• If tool is to be unused for an extended period, add 6 drops of air tool oil directly to the air inlet
then store the tool, handle up.
• With the air supply disconnected, periodically check that the backing pad is tight.
TROUBLESHOOTING
PROBLEM
Tool Doesn't
Respond
to Trigger
Depression
Tool
Performance
is Slow or
Sluggish
Tool Vibrates
Excessively
During Use
Tool Emits
Excessive or
Unusual Noise
During Use
To order parts and supplies: 800.345.1178 >> eastwood.com
CAUSE
Insufficient
CFM at tool
inlet (7.1 CFM
minimum)
Tool con-
taminated by
moisture
Insufficient
CFM at tool
inlet (7.1 CFM
minimum)
Tool con-
taminated by
moisture
Cracked,
broken or loose
backing pad
Lack of
lubrication
in air motor
CORRECTION
Verify sufficient air supply to tool.
Check for moisture in air line and tool air inlet.
Verify sufficient air supply to tool.
Check for moisture in air line and tool air inlet.
Stop use immediately and check for cracked or
broken backing pad.
Check for loose backing pad.
Stop use immediately, remove Oil Fill Screw and
add a quality Air Tool Oil until an oil level is seen.
7
Advertisement
Table of Contents
