Table of Contents
Advertisement
TROUBLESHOOTING
PROBLEM
Does Not Run
When Switch
is Turned On
Motor Runs
Too Slow/
Develops Low
Power
Sander Does
Not Effectively
Remove
Material
Excessive
Noise and/or
Vibration
Motor
Overheats
To order parts and supplies: 800.345.1178 >> eastwood.com
CAUSE
No power
to Sander
Excessive volt-
age drop due
to local power
company volt-
age supply
Excessive volt-
age drop due
to Under-sized
and or too long
of an extension
cord used
Abrasive Disk
worn
Abrasive Disk
likely torn or
damaged.
This
WARNING:
is an extremely
unsafe condi-
tion!
Excessive
pressure being
applied while
sanding or
grinding
Dirt and cutting
debris buildup
in motor cool-
ing air slots
CORRECTION
Check 120 VAC input plug connection.
Check for tripped circuit breaker. The Sander
operates on a 15 Amp Minimum circuit.
Use at another location or at a time when voltage
is higher.
Extension cords not recommended. If necessary,
use only 16 Gauge or larger cord and limit length
to 25'.
Check Abrasive Disk condition and replace per
"ABRASIVE DISK REPLACEMENT" section in
these instructions.
Discontinue use and replace Abrasive Disk.
Allow Disk to cut by rotation alone. Do Not Force.
Use a brush or compressed air to remove debris.
11
Advertisement
Table of Contents
