HP 8920A Application Handbook page 240

Using the Oscilloscope
Measurements Using the Main Control Fields:
• Vert/div selects the vertical amplitude per division.
Units for this field are in Volts, kHz, or percent depending on the AF Anl
In selection.
• Vert Offset moves the displayed signal above or below the center graticule
line.
• Time/div selects the horizontal sweep time per division.
Indicators:
•
•
•
238
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Input source is displayed in the lower left corner of the display.
Marker Time ms changes the units that the marker position is displayed
in. Displayed value is the time elapsed from the trigger point to the cur-
rent position.
Marker Lvl V/kHz/% changes the units that the marker position is dis-
played in. Displayed value is the signal level at the current position.