HP 8920A Application Handbook page 178

SSB Receivers
On the Radio set the Receiver's Controls as follows:
10. Set power to ON.
11. Set mode to LSB or USB.
12. If required, set frequency to the same value as
13. Set squelch to minimum.
14. Set RIT to center or disable (if equipped).
15. Set RF Gain to maximum (if equipped).
On the Test Set using the knob and data entry keys:
16. Change the value of RF Gen Freq until the AF Freq meter reads 1 kHz.
On the Radio set the Receiver's Controls as follows:
17. Set the Receiver's volume control until the AC Level meter indicates the
Receiver's rated output power.
Refer to audio output specifications for the Receiver being tested as
required. If unknown, increase the volume control until the AC Level
meter stops increasing (or at maximum).
Measurement results are displayed on the Test Set as shown.
176
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
RX TEST
AC Level
AF Freq
kHz
1.08224
Avg
RF Gen Freq AFGen1 Freq AFGen2 Freq Filter 1
28.310700 1.0000 1.0000 50Hz HPF
MHz kHz kHz
Amplitude AFGen1 To AFGen2 To
Filter 2
-47.0
FM FM 15kHz HPF
dBm Off Off
Atten Hold
On/Off
Ext Load R
Output Port
RF Out/Dupl
step 4.
W
Audio Output
2.010
To Screen
RF GEN
RF ANL
AF ANL
SCOPE
SPEC ANL
ENCODER
DECODER
RADIO INT
8.00
Ω
More