Table of Contents
Advertisement
5.4.7 Air Exchange Setting＊
Turn on air Exchange function:
Under on-state of the unit, press Function button to go to the this function setting (Air mark blinks).AIR 1 displayed
at the ambient temperature-displayed location (888) is defaulted (the last type of AIR will be displayed after
adjustment).Press
or
turning on this function, the air mark shows.
There are 10 types of AIR, but only 1-2 types are for remote control. Refer to the following details:
1
The unit continuously runs for 60min, and fresh air valve runs for 6 min.
2
The unit continuously runs for 60min, and fresh air valve runs for 12 min.
3
The unit continuously runs for 60min, and fresh air valve runs for 18 min.
4
The unit continuously runs for 60min, and fresh air valve runs for 2 4 min.
5
The unit continuously runs for 60min, and fresh air valve runs for 30 min.
6
The unit continuously runs for 60min, and fresh air valve runs for 36 min.
7
The unit continuously runs for 60min, and fresh air valve runs for 42 min.
8
The unit continuously runs for 60min, and fresh air valve runs for 48 min.
9
The unit continuously runs for 60min, and fresh air valve runs for 54 min.
10
The unit continuously runs for 60min, and fresh air valve always runs.
Turn off air Exchange function: During Air function, press Function button to go to the Air function. In this case, air
mark is blinking, and then press Enter/cancel button to turn off this function. Air mark will subsequently disappear.
Air Exchange setting is shown as in fig.5-11:
Note: In air exchange mode, press Function button or there is not any operation within 5s after the last button
operation, the system will be quit from air exchange setting and current energy-saving data won't be memorized.
button to adjust air type. Press Enter/Cancel button to turn on/off air function. After
Fig.5-11 Air exchange device
19
Hide quick links:
Advertisement
Table of Contents
