McQuay MQS-24018-CFC216A Installation And Operation Manual page 13

3. "+" and "–" button
Press the "+" or "–" button to set your desired temperature. The temperature ranges from 16
necessary to set temperature at the AUTO mode. And when setting the timing hours, press the "+" or "–" button
once, and the timing hours will increase or decrease 0.5 hour.
4. "FAN" button
Press the "FAN" button to set fan speed. The AUTO FAN, LOW, MID or HIGH could be selected.
5. button
Press this button to turn on or turn off the swing function.
6. "SLEEP" button
Press this button to set the sleep mode. Once the SLEEP mode is set, the temperature increases 1℃ after 1 hour,
and another 1℃ increase after 2 hours in the COOL mode. While in HEAT mode, the temperature will decrease 1℃
after 1 hour, and another 1℃ decrease after 2 hours.
7. "TIMER" button
Press the button to set the timing function. When the timing function is on, press this button to cancel it. When
it is off, press this button once to start and "Hour On/Off" will appear and flash in the display. In this case, press the
+/- button to adjust time (press the +/- button continuously to change timing value quickly). The setting time ranges
from 0.5 to 24 hr. Press this button once again to fix the time, then remote controller sends out signals immediately
and" Hour On/Off" will stop flashing. It will quit timer mode in case of flashing for 5 consecutive seconds without
pressing. If timing is set, press this button once again to quit it.
About AUTO RUN ：
When AUTO RUN mode is selected, the setting temperature would not be displayed on the LCD .The unit
automatically selects the suitable running mode and makes ambience comfortable in accordance with room temp.
About LOCK：
Press "+" and "–" simultaneously to lock or unlock the keyboard. If the remote control is locked, the icon
will be displayed on the LCD, in which case, press any button, and the mark will flicker for three times. If the
keyboard is unlocked, the mark will disappear.
About switch between Fahrenheit and Centigrade：
Under the state of unit off, press MODE and – buttons simultaneously to switch °C and °F.
9
to 30 .It is not