hergom Compact C-10 Series Installation, Use And Maintenance Instructions page 18

3. DISMANTLING THE VENTILATOR
ATTENTION! Make sure that the appliance is unplugged before handling any electrical parts.
To change the ventilators proceed as follows:
Fig.1
3. Replace the ventilator and put it back in position by following the above instructions but
in the reverse order.
4. ELECTRICAL OUTLINE
Switch positions.
- POSITION "0" : The fans will start-up at HALF SPEED AUTOMATICALLY when a fire is burning in
the unit and the cast iron parts reach a temperature of 50 ºC (in the area where the thermostat is
located).
When the flame goes out and the temperature of the cast iron parts falls below 50 °C, the fans stop.
This position is RECOMMENDED when the user wants the fans to stop working once the compact
fireplace has cooled off.
1. Release the front grille by loosening the
Fig.3
2. Release the fan by loosening the two
screws that hold it in place at the bottom
(Fig.3). Disconnect the fan's faston terminals.
two screws at the bottom (Fig.1 and
Fig.2)
Fig. 4
Fig.2