What Is Required For Configuration; Connecting The Lxn 500 To A Laptop - Motorola LXN 500 Installation, Configuration And Operations Manual

What is Required for Configuration

Before starting to configure the LXN 500, obtain the following:
LXN 500 power supply unit.
1.
Ethernet cable.
2.
USIM cards for your mobile devices with information list that includes: identity, authentication,
3.
operator code etc.
Operation information given by your authorities: frequency band, bandwidth, either downlink central
4.
frequency in MHz or DL EARFCN, physical and logical cell ID and PLMN.
Laptop computer (With Google Chrome browser installed), mouse and keyboard.
5.

Connecting the LXN 500 to a Laptop

The LXN 500 is configured by using Google Chrome to browse and access the LXN 500 Operation &
Management (O&M) site on the LXN 500.
Before connecting the LXN 500 to a laptop, verify the laptop is disconnected from any wired
IMPORTANT
LAN connections and disable all wireless LAN connections.
Perform this procedure to connect the LXN 500 to a laptop.
Procedure:
Obtain the LXN 500 UID number from the information label on the LXN 500 (See
1.
Set the parameters of the Local Area Connection of the laptop as described below.
2.
For example: in Windows 10; in the search box on the taskbar, type
and then select View network connections → Properties → Networking tab → under This
connection uses the following items, select Internet Protocol Version 4 (TCP/IPv4) →
Properties → and set the following:
Use the following IP address:
•
IP address, Subnet musk:
•
Default gateway:
•
Connect an Ethernet Cable between the LAN Port of a laptop and the MNG Port on the LXN 500.
3.
Connect the Power Supply Unit to the LXN 500.
4.
Power on the LXN 500 (See
5.

Connecting the LXN 500 to a Laptop

Figure 2-2
Send Feedback
10.98.66.2
255.255.0.0
10.98.66.<UID>
Powering On on page
LAN Port
Operation and Configuration
View network connections
18).
Power Supply Unit
PW R
MN003563A01-B
Figure 2-1).
,
MNG Port
Ethernet Cable
19