Motorola LXN 500 Installation, Configuration And Operations Manual page 36

MN003563A01-B
Operation and Configuration
In the iperf command field, edit the iperf default command line to customize the communication
3.
tests using the following command line arguments:
Command Line Structure
iperf [-s|-c <Host>] [-u] [-p <Port>] [-B <Interface>] [-c] [-b <Bandw>[kKmM]] [-l <Length>] [-t <Time>] [-d]
[-r] [-L <Port>] [-h]
iperf
Command Line Options
Table 2-4
Command Line Option
Client/Server
-u, --udp
-p, --port <Port>
-B, --bind <Interface>
Server Specific
-s, --server
Client specific
-c, --client <Host>
-b, --bandwidth
<Bandw>{kKmM}
-l, --len <Length>
-t, --time <Time>
-d, --dualtest
-r, --tradeoff
-L, --listenport <Port>
Miscellaneous
-h, --help
Using ping
36
Description
Uses UDP instead of TCP.
Connects with or expects data packets on this port (default: 5001).
Permits the connection only via the specified interface (IP address or
interface name).
Starts iPerf in server mode and waits for an iPerf client to contact it.
Starts iPerf in client mode and connects with the iPerf server <Host>
(IP address or DNS name).
Limit the [down]/up-stream bandwidth when analyzing a UDP
connection. This Is specified as kilobytes (kK) or megabytes (mM)
per second (default: 1 Mbps).
Sets the length of the UDP data packets.
Sets the duration of the connection in seconds (default: 10 seconds).
The test is bidirectional: the iPerf server and client send and receive
at the same time.
The test is sequential: the iPerf server and client send and receive
one after the other.
Specifies the port where the device in bidirectional mode expects to
receive data packets from the remote iPerf server (default: 5001).
Outputs the help text.
Ping Command Line Structure:
ping [-t] [-a] [-n count] [-l size] [-f] [-i TTL] [-v TOS] [-r count] [-s count]
[[-j host-list] | [-k host-list]] [-w timeout] [-R] [-S srcaddr] [-4] [-6]
target_name
Send Feedback