Mounting The Hs20 Laser Onto A Machine Page - Renishaw HS20 Installation Manual

24
Mounting the HS20 laser onto a machine
Fitting the baseplate to the machine
Information related to the specific dimensions and mounting hole locations can be found within the
under the headings HS20 external dimensions and mounting holes and Mounting plate external
dimensions and mounting holes within this section.
1. Place an M8 washer over each of the three mounting holes on the machine. The washers must
be fitted to avoid distortion of the baseplate. (Note: additional washers may be added if required)
as shown in figure 19.
2. Lower the baseplate onto the washers ensuring the holes remain aligned.
3. Secure the baseplate to the machine using two M8 x 16 mm cap head screws.
M-8003-2356
Base Plate
Fitting the alignment plate to the baseplate
1. Lower the alignment plate onto the baseplate ensuring that the holes remain aligned.
2. Fit the rectangular nut under the rear of the baseplate.
3. Fit (but pinch tighten only) as shown in figure 20
- one M8 x 20 mm cap head screw at the rear
- two M8 x 20 mm cap head screws and custom washers at the front
P-SC01-0820-M8 x 20
(Qty-2 off)
P-WA01-0080-RT
M8 Washer (Qty-2 off)
Figure 19 - Fixing the baseplate
Figure 20 - Fixing the alignment plate to the baseplate
P-SC01-0816-M8 x 16
(Qty-3 off)
P-WA01-0080-RT
M8 Washer (Qty-3 off)
M-8003-2357
Alignment Plate