Space Requirements For The Hs20 - Renishaw HS20 Installation Manual

Space requirements for the HS20

Before mechanical installation of the HS20 can be performed a mounting location must be decided.
The position should be chosen by consideration of the following:
Clearance required to adjust
HS20:
Clearance required to adjust
alignment plate:
Beam path requirements
the full length of the axis requires the clearances detailed below:
Standard linear optics kit:
Long range optics kit:
Minimum 250 mm (10 in) above the HS20 laser head
Minimum 150 mm (6 in) on each side
Figure 4 - Space requirements for HS20
To enable the measurement retroreflector to travel unimpeded down
With ducting:
Without ducting:
With ducting:
Without ducting:
Minimum 60 mm x 60 mm (2.4 in x 2.4 in)
Minimum 50 mm x 50 mm (2 in x 2 in)
Minimum 130 mm x 160 mm (5.2 in x 6.3 in)
Minimum Ø 90 mm (Ø 3.6 in)
13