Table of Contents
Advertisement
Fitting the optical plate to the alignment plate
1.
Take the M8 x 16 mm cap head screw and fit into the pillar
2.
Hold the flat on the pillar parallel to the beam path using a 13 mm spanner
3.
Whilst maintaining the pillar orientation, tighten the cap head screw
Fitting the HS20 laser
1. Fit the three adjustable feet to the HS20 laser head, setting them mid-way along their threaded
section to allow full adjustment in both directions. as shown in figure 21.
2. Take the semi-circular spacer and place it in the rear foot mounting position on the alignment
plate. Take the conical washer (P-WASH-0003-RT) and fit this into the counterbore at the front
left foot mounting position.
3. Mount the laser head carefully onto the alignment plate.
4. Place 3 copper wave washers (P-WA16-002-RT) (supplied) into the adjustable feet.
Adjustable Feet
M-8003-2358 Pillar
(Qty-1off)
5. Insert three M5 x 12 bolts (P-SC01-0512) into the adjustable feet and take up slack but
do not fully tighten.
6. Screw the pillar (M-8003-2358) into the position shown in figure 21.
Figure 21 - Fitting the laser to the alignment plate
25
P-SC01-0512
M5 x 12 (Qty-3off)
Advertisement
Table of Contents
