Forced Usb Update - GRAUPNER mz-16 HoTT Manual

Forced USB Update

5. As soon as the update is successfully completed, the transmi er
restarts.
If the forced update fails due to a missing update
follows:
1. Press and hold the lower two bu ons on the le and right of the
display while turning on the transmi er.
2. As soon as the ON / OFF switch border lights up orange, press and
hold the two middle bu ons on the le and right of the display.
3. When the border of the ON / OFF switch turns red, release the keys
4. Following the instruc ons in the transmi er display, connect the
transmi er to the PC or laptop via USB cable.
As soon as the connec on is established, the message "USB Mass
Storage Connected" appears in white text on the transmi er's
display.
In the e explorer of the PC or laptop appears a drive "MZ-16 (X :).
5. As described above in previous points "Upda ng the Transmi er"
load a suitable for upda ng the mz-16 HoTT transmi er onto the
transmi er.
6. Switch o the transmi er and disconnect the USB cable from your
computer.
7. Do a forced update as described above.
Page 45 of 48
e, then proceed as
S1047.mz-16-V1.0-EN