Windows Nt 4.X Network; Introduction; Preliminary Steps; Quick Install Steps (Tcp/Ip Protocol) - Xerox Phaser 2135 Install Manual

Windows NT 4.x Network

Introduction

Your printer can be installed on a Windows NT network using one of
two methods:
TCP/IP protocol
I
AppleTalk protocol
I
The Preliminary Steps given below must be accomplished for all
printers regardless of the protocol that is being used. Then, the Quick
Install Steps will detail the installation based on the protocol used on
your network.
The CentreWare DP program on your Printer Management Software
CD-ROM can also be used to monitor and configure the printer.

Preliminary steps

1. Print the Configuration Sheet. Details are in this document in
Appendix A: Print the Configuration Sheet on page 26. Retain this
page for reference.
2. Check the Configuration Sheet and verify that both the desired
protocol and connector are enabled.
3. Proceed to the Quick Install Steps for your network protocol.

Quick install steps (TCP/IP protocol)

1. At the Desktop, right-mouse-click the Network Neighborhood
icon and select Properties.
2. Click on the Protocols tab and verify that the TCP/IP protocol has
been loaded.
3. Select the Services tab and verify that Microsoft TCP/IP Printing
is loaded.
4. If this software is not present, install it using the documentation
provided by Microsoft. Then return to this document.
5. Open the Control Panel and double-click the Printers icon.
Quick Network Install Guide
7