Advertisement
INSTRUCTION MANUAL
3.7 Pump Installation (Fig. 12)
WARNING : WHEN LIFTING THE PUMP, USE APPROPRIATE CRANE (OR
!
HOIST) AND LIFT SYSTEM.
CHECK POSITION AND TIGHTNESS OF LIFT SYSTEM SO THAT WEIGHT OF
THE PUMP IS NOT UNBALANCED.
FAILURE TO OBSERVE THIS PRECAUTION CAN RESULT IN SERIOUS
ACCIDENTES.
After the pump has been thoroughly checked to verify that it is in order, lift the pump
body and fit the sliding guide of the pump body to the guide pipe. Then, lower the
pump body slowly along the pump guide.
The pump is automatically connected to the discharge elbow.
If the pump cannot be slid down smoothly, the guide pipe may not be vertical or the
lifting method may be wrong. Check these points to determine the cause for
correction.
After the pump is installed attach the chain to the hook of the floor frame.
When the pump is installed indoors, it should be a good idea for convenience's sake
that a hoist, for example, be provide on the ceiling so that it can be moved to the
pump lifting center when necessary.
PM32U
SLIDING GUIDE
GUIDE PIPE
CHAIN HOOK
DISCHARGE ELBOW
Fig. 12
P.14
Advertisement
