Where To Put The Restraint - HOLDEN MY18 TJ Trax Owner's Manual

Where to put the restraint

Warning
Child restraint anchorages are
designed to withstand only those
loads imposed by correctly fitted
child restraints. Under no
circumstances are they to
be used for adult seat belts,
harnesses, or for attaching
other items or equipment to
the vehicle.
Only child restraints that have
clips to attach to the vehicle's
anchorage fittings are to be used.
Other types of child restraints
may not attach securely to this
type of anchor.
Use only Standards Australia
and New Zealand approved child
restraints and harnesses. Only
purchase a child restraint which
carries the appropriate Standards
Australia sticker of approval.
Where legally allowable, you
may install a forward-facing child
restraint in the front seat, but
always move the passenger's
seat as far back as it will go.
The forward facing child restraint
must still be attached to the
passenger side child restraint
anchorage point, located behind
the rear seat.
Remember, it is safest for
children to be seated in the
rear seat.
Note
If unsure about installing a child
restraint, contact an approved
restraint fitting station or a Holden
Dealer.
Seats, restraints
ISOFIX child restraint systems
Fasten vehicle-approved ISOFIX
child restraint systems to the ISOFIX
mounting brackets.
Note
Ensure the seat belt buckles are
placed out of the way of the child
seat.
ISOFIX mounting brackets are
indicated by a label on the seatback,
as shown. In addition to the ISOFIX
mounting, fasten the top-tether straps
to the top-tether anchorage points.
Top-tether child restraint systems
0 56
55