Tyre Changing - HOLDEN MY18 TJ Trax Owner's Manual

206 Vehicle care
25. Continue driving immediately so
that sealant is evenly distributed
in the tyre.
26. After driving approximately 10 km
(but no more than 10 minutes),
stop at a safe location to check
the tyre pressure.
27. Screw the compressor air hose
directly onto the tyre valve and
compressor to check the tyre
pressure.
28. If the tyre pressure is more than
1.3 bar, set it to the correct value
(approx. 2.4 bar).
29. Repeat the procedure from Step
25 until there is no more loss of
pressure.
If the tyre pressure has fallen
below 1.3 bar, do not continue
driving. Contact a Holden Dealer.
30. Dispose of the used tyre sealant
canister at a Holden Dealer or in
accordance with local and State
codes and practices. Replace
with a new canister.
31. Stow the tyre repair kit behind
the cover on the driver's side, in
the load compartment.
This is a temporary puncture repair.
Take the vehicle to a Holden Dealer
to have the tyre repaired or replaced
as soon as possible.

Tyre changing

The vehicle may have a spare tyre.
Warning
Failure to observe the following
preparations and instructions may
result in damage or injury:
• Passengers must be out of the
vehicle when it is being jacked.
• Do not jack a vehicle with a
trailer attached. Remove the
trailer first.
• Only jack the vehicle on hard,
level surfaces.
• Ensure moving parts of the
jack are adequately lubricated
before use.
• Use the jack only at the
designated lifting points. Use
in other locations may result in
the vehicle falling off the jack, or
damage to the vehicle.
• Do not start or run the engine
while the vehicle is supported
by the jack.