Seat Belts - HOLDEN MY18 TJ Trax Owner's Manual

8. Place the seat belts into the belt
guides.
To return the seatback to the upright
position:
1. Pull the seat belt away from the
belt guide.
2. Lift the seatback upwards and
push firmly back into place.
Note
Ensure the seat belt is clear of
the latch.
3. Return the rear seat cushion to
its original position. Push the
front part of the cushion down
firmly until it latches.
Note
• Ensure the seat belt buckles are
not trapped.
• The centre rear seat belt may
lock when returning the seat
cushion. If this occurs, pull the
strap to release the seat cushion,
withdraw the belt slightly and
return the seat cushion.
Warning
When passengers are in the rear
seats ensure the rear seatbacks
are all the way back and locked
in position, before starting the
vehicle.
Do not pull the release levers
on top of the seatback while the
vehicle is moving. Damage to the
vehicle or injuries to occupants
may occur.
Seats, restraints

Seat belts

Warning
Seat belts are designed to bear
upon the bony structure of the
body, and should be worn low
across the front of the pelvis or
the pelvis, chest and shoulders,
as applicable; wearing the lap
section of the belt across the
abdominal area must be avoided.
Seat belts should be adjusted as
firmly as possible, consistent with
comfort, to provide the protection
45