Table of Contents
Advertisement
Option MTU and MTP, MultiTouch User Interface Upgrade Kits
Installation Procedure
Analyzer Information
1. Connect a power cord to the analyzer and turn on the analyzer.
2. After the analyzer has completed turning on, press System, Show, System. Make note of the
following information from the Show System screen:
Product Number: _____________
Serial Number: ______________
Instrument S/W Revision: ______________
3. Check for the presence of one of the following options listed below in the Show System
screen. Put a check mark or "X" after the option listed below that appears in the Show System
screen.
N9010A-PC1_____
N9010A-PC2_____
N9010A-PC3_____
N9010A-PC4_____
N9010A-PC5_____
N9010A-PC6_____
N9010A-PC7_____
N9010A-532_____
N9010A-544_____
N9010A-EXM_____
4. Refer to the data in
the installation of this kit. This kit is to be installed only on N9010A signal analyzers.
5. Refer to the data in
currently installed CPU is either N9010A-PC1, N9010A-PC2, N9010A-PC3, N9010A-PC4, or
N9010A-PC5, do not proceed with the installation of this kit. This kit is to be installed only on
N9010A signal analyzers with N9010A-PC6 or N9010A-PC7 CPUs.
6. Refer to the data in
the currently installed CPU is N9010A-PC6 or N9010A-PC7, do not proceed with the
installation of this kit. This kit is to be installed only on N9010A signal analyzers with
N9010A-PC1, N9010A-PC2, N9010A-PC3, N9010A-PC4, or N9010A-PC5 CPUs.
7. Refer to the data in
steps required to remove and replace the front panel assembly.
8
step 2
above. If the Product Number is not N9010A, do not proceed with
step 3
above. If upgrade product N9010A-MTU is being installed and the
step 3
above. If the upgrade product N9010A-MTP is being installed and
step 3
above. If Option N9010A-EXM is installed, there will be additional
Installation Note N9010-90072
Advertisement
Table of Contents
