Installation Procedure Over Usb - Keysight N9030B Installation Note

Tools Required for Installation
— Personal computer with internet access and USB port
— USB storage device with > 2 GB free memory
Tools Required for Manual Operation Verification
— Voltmeter
— Test cable, BNC (used to connect voltmeter to the analyzer rear panel ANALOG OUT)
— Banana plug to BNC adapter (used to connect voltmeter to BNC cable)

Installation Procedure over USB

1. Locate the Option Upgrade Entitlement Certificate (5964-5178) from the kit.
2. Redeem the Option Upgrade Entitlement Certificate by following the instructions on the
Certificate.
3. After redeeming your Option Upgrade Entitlement Certificate you will receive an email with an
attached License File.
4. Locate a USB storage device. Perform a virus scan on this device before use.
5. Save the License File to the root directory of the USB Storage Device.
6. Connect the USB Storage Device to the signal analyzer USB port. Windows will detect the new
hardware and may display the configuration menu shown in
configured according to your preferences.
Figure 1 USB Storage Device Configuration Menu
Installation Note N9030-90086
Option YAV Installation Kit
Figure 1. This menu may be
5