Enabling A Print Server; Rebuilding The Raid Array - Buffalo LinkStation 200 Series User Manual

Chapter 9 Configuring from Mobile Devices
Note: By default, the Direct Copy folder is configured to the "share" folder. You can change the destination
folder from Settings using the computer. Refer to the
procedure.
5
When the copy operation is finished, the access LED of the USB device will stop flashing. Safely dismount the
USB device by using the dismount process.

Enabling a Print Server

1
From Settings, tap [USB Device].
2
Move the print server switch to the on position to enable print server and tap [Apply].

Rebuilding the RAID Array

You can also initiate the RAID rebuild from your mobile device.
1
Turn the LinkStation off and remove all cables.
2
Squeeze the left side of the front panel and swing it open.
3
Push the failed drive's cartridge up and remove it from the LinkStation.
4
Unscrew the four screws and remove the drive from the cartridge.
5
Install a new drive (sold separately) into the cartridge.
"Copying from a USB Device"
125
section in chapter 6 for the