Buffalo LinkStation 200 Series User Manual page 130

Chapter 11 Appendix
Amber (Blinking)
After you change any settings, the power LED will blink amber. The pattern of the blink gives the information code.
You can also confirm the current status by using NAS Navigator2.
Place
10s Place
1s Place
Code
I10
I11
I12
I13
I14
I15
I16
I17
I18
I19
I20
I21
I22
I23
I25
I26
I27
I28
I46
I47
Status
The LED flashes for 1 second every 0.3 seconds. This gives the tens place of
the information code.
The LED flashes for 0.5 seconds every 0.3 seconds. This gives the ones place
of the information code.
Description
A rise in the system temperature may have
exceeded the allowable safety value.
The drive has too many bad sectors.
Operating in degraded mode.
Formatting the RAID array.
Checking the RAID array.
Examining the error status of the RAID
array.
Note: Transfer speeds are slower during
the examination process.
Creating the RAID array.
Resynchronizing the RAID array.
Note: Transfer speeds are slower during
resynchronization.
Rebuilding the RAID array.
Note: Transfer speeds are slower during
the rebuilding process.
Rewriting the RAID array.
Formatting the drive.
Checking the drive.
Rewriting the drive.
The initialization process has been started
by using the function button and settings
are being initialized.
Updating the LinkStation firmware.
The initialization process has been started
by using Settings and all settings are being
initialized.
Checking the USB drive.
Formatting the USB drive.
Data migration or conversion (RAID
migration) is in progress.
Data migration or conversion (RAID
migration) is in progress.
Corrective Action
Move the LinkStation to a cool location. Do
not place objects in the area around the
LinkStation.
Replace the drive by referring to the
Replacement"
Check if the
it is, refer to the corrective action for the
E30
error.
-
-
-
-
-
-
-
-
-
-
-
Do not turn off the LinkStation's power.
Do not turn off the LinkStation's power.
-
Do not turn off the LinkStation's power.
Do not turn off the LinkStation's power.
Do not turn off the LinkStation's power.
129
"Drive
section in chapter 4.
E30
error is also displayed. If