Connecting A Printer - Buffalo LinkStation 200 Series User Manual

Chapter 7 Multimedia
Select "Start when added" to start downloading immediately after clicking [Upload].
4
The download will start.
To cancel downloading, click

Connecting a Printer

You can connect a printer to the USB port on the LinkStation.
Follow the procedure below to configure a print server. To configure a print server from a mobile device, refer to the
"Enabling a Print Server"
Notes:
• Only one USB printer can be connected to the LinkStation.
• Bidirectional communication is not supported i.e., remaining ink quantities and other printer status information is
not displayed.
• Don't disable the SMB protocol while the print server is enabled. If you do, you will need to enable SMB again and
reconfigure the print server from scratch.
1
Connect a printer to the LinkStation's USB port, then turn the printer on.
2
From Advanced Settings, click [Services].
3
Move the print server switch to the
4
Refer to the manual supplied with the printer and install the printer drivers.
5
Launch NAS Navigator2. Double-click your LinkStation's icon.
6
Double-click the icon of the connected printer (the shared name is displayed).
, then [Remove]. Click
section in chapter 9.
to pause the download. Click
position to enable the print server.
87
or to resume.