Raid Scanning - Buffalo LinkStation 200 Series User Manual

Chapter 4 Storage Management
4
Set the RAID mode to "RAID 1".
5
Select the "Add a disk to RAID array with RMM. Your data will be preserved. " checkbox.
6
Select the drive whose data will be saved from the drop-down list.
7
Select the drive to add to the RAID array.
8
Click [Create RAID Array].
9
The "Confirm Operation" screen will open. Enter the confirmation number, then click [OK].
10
Click [OK] when completed.

RAID Scanning

A RAID scan checks your RAID array for bad sectors and if it finds any, it automatically repairs them. Only RAID 1
arrays are supported. For best results, run a RAID scan regularly.
1
From Advanced Settings, click [Drives].
2
Move the RAID scanning switch to the
3
Click to the right of "RAID Scanning".
position to enable RAID scanning.
44