Enabling Direct Copy; Starting Direct Copy - Buffalo LinkStation 200 Series User Manual

Chapter 6 Backup

Enabling Direct Copy

1
From Advanced Settings, click [Backup].
2
Move the Direct Copy switch to the
To change the Direct Copy target folder, navigate to [Backup] > [Direct Copy] > [Edit], select a new folder, and
click [OK].

Starting Direct Copy

1
Connect the USB device. When it mounts (about 10 seconds), the function LED will light up.
Notes:
• Devices that don't trigger the function LED to light up are not supported.
• When you connect PTP devices, the function LED may not light up. In such case, disconnect the PTP device
from the LinkStation once, then reconnect it.
2
You now have 60 seconds to press the function button once. If you do, the function LED will flash as all the files
on the USB device are copied to the Direct Copy folder of the LinkStation.
Notes:
• While the function LED is flashing, press the function button once to cancel Direct Copy.
• For digital cameras that are not in the USB mass storage class, all files from the digital camera are copied.
3
When the copy operation is completed, the access LED of the USB device will stop flashing. Dismount the USB
device from the LinkStation by referring to the
position to enable Direct Copy.
"Dismounting Drives" section in chapter 4.
75