Advertisement
NOTE: Screws are not included with dispenser.
1.
Hold dispenser up to desired location and mark two
holes on the wall where screws will be inserted.
(See Figure 2)
Figure 2
SCREW LOCATIONS
1.
Remove perforated tab from toilet seat cover pack.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 2 OF 2
MOUNTING INSTRUCTIONS - SCREWS
LOADING INSTRUCTIONS
Figure 4
1-800-295-5510
2. Drill into wall at two marked locations with
appropriate-sized drill bit. Insert wall anchors if
necessary. (See Figure 3)
Figure 3
3. Hold dispenser over previously drilled holes and
insert screws.
2. Insert pack from bottom of dispenser. Push the bottom
of the pack towards the front of dispenser to keep it in
place. (See Figure 4)
uline.com
0620 IH-878
Advertisement
