Bypass Transport Specifications - Xerox DocuPrint 180 NPS Installation Planning Manual

PRINTER SPECIFICATIONS AND REQUIREMENTS

Bypass transport specifications

6-12 XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 96/4635/180 NPS
The bypass transport option enables you to add a third-party finishing
device to your 96, 4635, or 180 printer. The bypass transport is
installed by your service representative and remains permanently in
place. You should not attempt to remove or reinstall it. The following
is supported by the bypass transport:
•
Paper size and weight — You can use all of the paper sizes
and weights supported on the 96/4635/180 in the bypass
transport.
•
Sheet exit orientation — 1 to N (the same order in which
sheets are fed from the printer), delivered face down.
•
Maximum throughput speed — The bypass transport for the
96 and 135 printer supports throughput speeds of up to 139
ppm (pages per minute). The 180 bypass transport supports
speeds up to 180 ppm. (These rates are based on stocks up to
9 by 14.33 / 229 by 364 mm in length.)
•
Sheet exit height — 34 inches / 86 cm above the floor.