End Panel - Steelcase Opus Manual

NOTE: Determine which base unit will
have the side panel attached.
1.
Turn base assembly on it's side.
Lower the end panel onto the base
assembly as shown (1a). Make
sure there is a 1/8" offset at the top
of the base assembly and make sure
the front of the end panel is 3/4" from
the front of the canopy (1b). The
bottom of the end panel will be flush
with the top of the base.
2.
Secure the end panel to the base
assembly by first squaring up the top
of the panel to the top of the base
assembly and installing three (3)
1-1/4" wood screws (2a).
NOTE: When squaring up top of panel
to top of assembly, be mindful of the
1/8" offset discussed in step 1.
Square up the back of the end panel
to the back edge of the base assembly
and install the five (5) remaining 1-1/4"
screws (2b).
1a
19-5/16"
REF.
1b
3.4"
1/8" OFFSET
INSTALL THESE FIVE (5)
1-1/4" WOOD SCREWS
ONE AT A TIME
BY FIRST SQUARING
UP BACK OF PANEL TO
BACK OF ASSEMBLY
2b
2a
INSTALL THESE THREE (3)
1-1/4" WOOD SCREWS
FIRST AFTER SQUARING
UP TOP OF PANEL TO
TOP OF ASSEMBLY

END PANEL

Page 2 of 12
939500290 Rev C