Chapter 7 Operation Examples; Programming Procedure - Mitsubishi Electric MELSEC iQ-R Series User Manual

7
OPERATION EXAMPLES
This chapter describes the programming procedure and the basic program of the D/A converter module.
7.1

Programming Procedure

Take the following steps to create a program for executing the D/A conversion. Programs for normal output mode and wave
output mode are described.
For normal output mode
1.
Set module parameters.
Page 30 Module parameter
2.
Create a program.
Page 34 Program examples
For wave output mode
1.
Set module parameters.
Page 37 Module parameter
2.
Configure the initial settings of the wave output function.
Page 40 Initial settings of the wave output function
3.
Create a program.
Page 43 Program examples
Using function blocks (FBs) reduces load at programming and improves the readability of programs. For
details on the function blocks, refer to the following.
 MELSEC iQ-R Analog-Digital Converter Module/Digital-Analog Converter Module Function Block
Reference
7 OPERATION EXAMPLES
7.1 Programming Procedure
7
29