Table of Contents
Advertisement
Chapter 6: Solving Problems
If you suspect that the emulator is broken
If you suspect that the emulator is broken
1 Shut off power to your target system, and then the emulator.
2 Disconnect the emulator from your target system.
3 Connect the emulator to the demo board. Also connect the power cable from the
emulator to the demo board.
4 Apply power to the emulator.
5 Type pv 1 to run performance verification.
If either the emulator or analyzer fail the performance verification, check the
installation of those modules. If the installation is correct, contact your local HP
Sales and Service office for assistance.
If emulation memory behavior is erratic
Check to see if you have installed HP 64171A or HP 64171B memory modules on
the emulation probe board. These memory modules are too slow to work with the
MC68360 emulator. Use HP 64172A, HP 64172B, and/or HP 64173A memory
modules.
Ensure that you have answered the configuration question correctly for the memory
modules in use. The configuration question establishes the required number of
wait states to be used within the emulator.
Check that emulation memory is not configured as DRAM.
120
Advertisement
Table of Contents
