Chapter 1: Preparing the Emulator
Step 5. Connect the power cord
Step 5. Connect the power cord
The HP 64700B automatically selects the 115 Vac or 220 Vac range. In the 115 Vac range, the
HP 64700B will draw a maximum of 345 W and 520 VA. In the 220 Vac range, the HP 64700B will
draw a maximum of 335 W and 600 VA.
If you have the emulator installed in an HP 64700A card cage, select the line voltage using a
thumb-wheel switch inside the power control module on the rear panel of the card cage. The input
frequency must be in the range of 48 to 66 Hz. At 115 VAC, the emulator will draw a maximum of
3.0 A. At 220 VAC, it will draw a maximum of 1.5 A.
The HP 64700 is shipped from the factory with a power cable appropriate for your country. You should
verify that you have the correct power cable for installation.
If the cable you received is not appropriate for your electrical power outlet type, contact your
Hewlett-Packard sales and service office.
30