Cleaning And Storage; Cleaning The Filter; Storage; Transport - Parkside PHWW 1200 A1 Translation Of The Original Instructions

GB IE

Cleaning and storage

Clean and maintain the filter (2) regularly.
This will ensure good performance and a
long service life.
Have any work that is not descri-
bed in this instruction manual per-
formed by our service centre. Only
use original parts.
Always remove the mains plug be-
fore working on the device.
There is a risk of electric shock or
injury from moving parts.

Cleaning the filter

Make sure that the filter (2) is cle-
aned regularly to maintain pump
capacity. Replacing a dirty filter.
1. Unscrew the filter cap (1). Remove the
filter (2).
2. Wash the filter (2) carefully with a
brush under clear running water. Do
not use any abrasive cleaning agents
or solvents.
3. Reinsert the filter (2) and screw the filter
cap (1) back on.
All other measures, particularly opening
the pump (6) must be carried out by a qua-
lified electrician.
Always contact our service centre in the
case of repairs.

Storage

• Store the device in a clean condition in
a dry place, out of reach of children.
• To store, open the drain screw (10)
and empty the water from the pump.
20

Transport

The carrying handle (5) can be used for
transporting.
Changing the switch-
on and cut-off pressure
(specialists only)
Attention! Before changing the pres-
sure, check whether the connection
cables and the connected end de-
vices can withstand the pressure!
Attention! Danger! Risk of electric
shock at the connection terminals in
the pressure switch when the cover
is removed. Only specialists may
open and configure the pressure
switch!
The pressure switch is configured at the fac-
tory so that most applications are covered.
This preconfiguration can be changed as
needed.
The larger screw/nut (I) is
for setting the switch-on
I
pressure and the smaller
one (II) is for setting the
II
pressure difference. The
pressure is changed by
turning them to the left or
right.
• Turning right increases pressure
• Turning left decreases pressure
Make sure the pressure difference is
always 1.5 bar.