Environmental Protection; Spare Parts/Accessories - Parkside PHWW 1200 A1 Translation Of The Original Instructions

The switch-off pressure must always be
less than the maximum operating pressure
of the pump and the diaphragm pressure
tank.
After configuring the pump, switch it on
and read the pressure gauge to check
whether the desired cut-off pressure and
switch-on pressure are met. If necessary,
repeat the configuration process above
until you achieve the correct switch-on and
cut-off pressure.

Spare Parts/Accessories

Spare parts and accessories can be obtained at www.grizzly-service.eu
If you have issues ordering, please use the contact form.
If you have any other questions, contact the "Service-Center" (see page 23).
Special key ............................................................................. Order no. 91105585
Filter cap................................................................................................. 91105586
Water particle filter ................................................................................. 91105587
Protective cap for air valve ....................................................................... 91105591
Disposal/environmental
protection
The device, accessories and packaging
should be properly recycled.
Electrical devices must not be dispo-
sed of with domestic waste.
• Take the device to a recycling plant.
The plastic and metal parts used on
your device can be properly sorted
according to materials and grades and
efficiently recycled. Please contact our
service centre for more information.
• Dispose of the box in paper recycling.
Dispose of plastic parts in the Dual Sys-
tem.
GB IE
21