Xerox 8825 User Manual page 148

The Scanner will not accept
a thick document.
The Scanner measures the
width of the original
incorrectly. The copy is
either wider than the
original or the copy is
clipped
When the Scanner is set to
exit to the front, the
document is difficult to
remove from the Scanner
Width detection failed when
scanning transparent
documents. Width sensors
in most cases will not detect
transparent documents.
Not Ready Media Jam
The Scanner does not
position the document
correctly before scanning.
Image quality
Vertical lines and streaks
are visible in the copy.
Visible document edges on
the copy.
Dark spots or smudges
appear on the copy.
The copy image is too light.
142 Problem solving
scanned.
Ensure that both the Scanner and the
Printer are powered up and initialized.
Refer to Cleaning the Platen Glass and
Document Drive Rolls. Wipe the
Document Feed Tray with anti-static fluid.
See the second item above in Scanner
Control
Raise the Thick Document Lever to
release the document. Be sure to lower
the Thick Document Lever before making
the next copy/scan.
Enter the document width.
Refer to Cleaning the Platen Glass and
Document Drive Rolls. Wipe the
Document Feed Tray with anti-static fluid.
Ensure that you are inserting the
document correctly.
Center the document between the marks
on the Document Feed Tray.
Smoothly insert the document into the
feed mechanism so that the lead edge of
the document is against the rollers before
the Scanner begins to stage the
document.
Clean the Platen Glass.
Try a lighter Contrast setting.
Clean the Platen Glass.
Adjust the Copy setting for best image
quality.
edge first.
Set the Thick
Document Lever to its
next higher setting.
Thick documents may
require operator
assistance.
Turn the AUTOWIDTH
off. See "Scanner
Control" in the "Main
Menu" section for
more information
Set the Scanner to
exit to the rear. See
"Scanner Control" in
the "Main Menu"
section for more
information.
Turn AUTOWIDTH off
and refer to "Scanner
Control" in the Main
Menu
If the document is For thick
folded, worn or documents,
damaged, use a set the Thick
document carrier or try Document
feeding a different Lever to its
edge. next higher
setting. Thick
documents
may require
operator
assistance.
Check the operation of
the optical paper
sensors. See
"Sensors" in the "Main
Menu" section for
more information.
Inspect the original Adjust the
and clean it if Copy setting
necessary. for best image
quality.
Rotate the original 90
degrees.
XEROX WIDE FORMAT COPY SYSTEM