Xerox 8825 User Manual page 28

22 Getting to know the WIDE FORMAT COPY SYSTEM
Next
The Next key highlights the following item in a displayed list.
Enter
The Enter key either confirms the selection of the currently highlighted
item or confirms an entered numeric value.
Exit
The Exit key cancels a selection operation and returns you to a previous
screen. It has other effects, depending upon the specific situation, that
are explained later.
Mode
The Mode key is a valid selection only when READY is displayed on the
screen. This key is used to switch between the READY TO COPY mode
and the READY TO SCAN mode. The SCAN mode can be entered only
if the Scan to Net feature key is loaded.
Below are examples of the READY screen in COPY and SCAN modes.
NOTE: The COPY mode is disabled foe X2 TECH
READY TO COPY
INSERT DOCUMENT
AUTO
READY TO SCAN
INSERT DOCUMENT
TIFF/CCITTG4
BIT
In the COPY mode, the scanned image, or set of images is printed on
the Printer and then deleted from the hard disk.
In the SCAN mode, the scanned image, or set of images, is stored on
the hard disk for later retrieval over a network by a client running on a
remotely located device. Refer to the "Scanning to the Network" section
for more information about the SCAN mode.
NOTE: The SCAN mode is an optional feature that is enabled by
installing the Scan to Net feature key Contact your XEROX
representative for ordering information.
100.0%
400 DPI
XEROX WIDE FORMAT COPY SYSTEM
1