Table of Contents
Advertisement
interface. Typical port parameters for the internal interface, such as speed, duplex,
VLANs, and more, can be configured via RUGGEDCOM ROX II.
IMPORTANT
Interface settings configured via RUGGEDCOM ROX II must be mirrored within the
RUGGEDCOM APE1808 module. For instance, if a VLAN is assigned to the module
in RUGGEDCOM ROX II, a corresponding VLAN must also be configured via the
module's operating system.
1
2
3
4
Figure 1.2
1.7
Default IP Addresses
Based on the software platform installed on the RUGGEDCOM APE1808, the
IP addresses for the front and/or internal ports may be pre-configured or set
dynamically by the Dynamic Host Configuration Protocol (DHCP).
Software Platform
Windows® 10 Enterprise 2019
LTSC
Debian Linux®
RUGGEDCOM APE1808 (Application Processing Engine)
Configuration Manual, 05/2022, C79000-G8976-1415-04
2
Switch Fabric Data Plane
Line Module (10/100/1000Base-TX)
RUGGEDCOM APE1808 Module
Gigabit Ethernet (GbE) Network Interfaces
A RUGGEDCOM RX15xx Device With an RUGGEDCOM APE1808 Module Installed
1
2
External Port (RJ45)
DHCP
DHCP
Overview
1.7 Default IP Addresses
3
Internal Port
DHCP
DHCP
4
7
Advertisement
Table of Contents
