Master Unit; Slave Unit; Master/Slave Operation States - Xantrex GT100E Owner's Manual

Master Unit

Slave Unit

Master/Slave Operation States

152602
If daily role reversal is on, then the configured slave is operational slave
on odd days (January 1,3,5,...) and operational master on even days
(January 2,4,6,...).
The GT100E Master inverter will control the
via a control cable. The Master inverter will enable and disable the Slave
inverter, and monitor the status of the Slave inverter through an
interconnect cable. If the interconnect cable is disconnected, the master
will open the combiner box and go online.
The GT100E Slave inverter will monitor the status of the Master inverter
through the interconnect cable. The inverter will be enabled from the
Master inverter. If the interconnect cable is disconnected then the slave
will go online.
The Master/Slave operation states will follow the standard states specified
by the GT100E Grid Tie Inverter Operation, Maintenance and
Troubleshooting Manual (P/N 152365)
configuration state.
1. At Power up, the Master inverter will disable the Slave inverter, and
close the contactor in the
2. The Master inverter will go online through the normal operating
States. The Slave inverter will remain disabled.
3. When the Master inverter's power level increases, and reaches the
High Power Threshold (configurable parameter). The Master inverter
will shutdown, open the contactor in the
and the Master will also enable the Slave inverter.
4. Both the Master and Slave Inverters will go to an online state.
5. End of the Day or Cloud Interaction - When the Master inverter's
power level decreases, and reaches the Low Power Threshold and has
maintained the power level for the Minimum Transition Seconds
(configurable parameter). The Master and the Slave inverters will
Master/Slave Operation States
GT100E MS
with the following Master/Salve
GT100E MS Combiner Box.
GT100E
Combiner Box
MSCombiner Box,
1–3