Recharging With The Dc Charging Cable - Xantrex XPower 400R Owner's Manual

To recharge with the AC Charger:
1. Disconnect any 12 V DC appliance and turn the light
switch to
2. Turn the AC Outlet
3. Plug the AC Charger into a standard AC wall outlet.
4. Insert the AC Charger cable end into the Charger Input
Socket located in the charger storage compartment.
5. While the XPower Powerpack is recharging, the green
Charging Status light is flashing. If the battery is
completely discharged, a typical recharge may take up to
35 hours. When fully charged, the green Charging
Status light changes to steady and the XPower
Powerpack is ready to use.
Important: The 35-hour charging time for the XPower
Powerpack assumes that there is 120 V at the AC wall outlet. If
the voltage is less than 120 V AC, it may take more than 35 hours
to fully recharge the XPower Powerpack. If, after 35 hours of
charging, the green Charging Status light is still flashing and not
steady, continue to charge the unit for another 15 hours.
Once the battery is fully charged, the charging voltage
and current automatically reduces to a maintenance level
and the XPower Powerpack may be left permanently
connected to the AC Charger. If your utility power is
interrupted, the charging process automatically restarts
when power returns.

Recharging with the DC Charging Cable

Using the DC Charging Cable, the XPower Powerpack can
be recharged while you drive your vehicle.
Important: Although the charge regulation circuitry in the
XPower Powerpack does not operate with this charging method,
most vehicle voltage regulators will ensure that the XPower
Powerpack is not overcharged.
975-0162-01-01
Recharging the XPower Powerpack Battery
.
OFF
/
ON OFF
switch to .
OFF
4-3