Worth Data RF Terminal 7000 Owner's Manual page 63

Properties - TCP/IP COM
Properties are the various configuration variables used by the WDIPterm control. They are directly
assignable in your application (e.g. "WDIPterm.ServerOn = true") and can be set in your development
environment's object browser.
Note that your development environment may show more properties for the WDIPterm control than are
listed here. This is normal. You may ignore properties you see listed in your development environment that
are not listed here.
ServerOn
Valid values:
Function:
Quiet
Valid values:
Function:
LogFile
Valid values:
Function:
ClientList
Valid Values:
Function:
Methods - TCP/IP COM
Methods are commands that you issue to the WDIPterm control. All of the "
terminal to wait for operator input.
Note that your development environment may show more available methods for the WDIPterm control than
are listed here. This is normal. You may ignore methods you see that are not listed here.
InputAny
Parameters: basename, channel, terminal, line, position, prompt, shifted, timestamped
Function:
InputKeyBd
Parameters: basename, channel, terminal, line, position, prompt, shifted, timestamped
Function:
InputScanner
Parameters: basename, channel, terminal, line, position, prompt, allowbreakout, timestamped
Function:
True, False
Set to True to enable the server. Set to false to turn the server off. You should leave this
off unless your program is actually running. Setting it to True at design-time can cause
problems.
True, False
If is set to True then any status and error message generated by WDIPterm will be
Quiet
suppressed.
blank or a valid file name
If the file does not exist it will be created. If it exists, it will be appended to. If
blank, no log file is maintained.
Read Only.
Returns a formatted string listing all attached client BaseNames and associated IP
numbers. Format is "basename CR/LF IP address CR/LF basename...".
This instructs the terminal attached to client basename on channel to display the prompt
at line and position and wait for data to be entered from either terminal keypad or
scanner. If shifted is set to "true", the terminal will start in shifted mode. Timestamped
appends a (hhmmss) prefix to the returned data.
This instructs the terminal attached to client basename on channel to display the prompt
at line and position and wait for data to be entered from the terminal keypad only. If
shifted is set to "true", the terminal will start in shifted mode. Timestamped appends a
(hhmmss) prefix to the returned data.
This instructs the terminal attached to client basename on channel to display the prompt
at line and position and wait for data to be entered from the terminal scanner only.
Setting allowbreakout to true allow user to "breakout" of scanner only mode by pressing
" commands cause the
Inputxxx
is
LogFile